LeeBoy 8510b - Safety Label Installation

7
LeeBoy Model 8510B Conveyor Paver 7-37
Maintenance
Safety Label Installation
Anytime the LeeBoy Model 8510B Conveyor Paver has
been repainted or the safety labels have been removed,
damaged or can’t be read, a new set of labels should be
ordered and reinstalled for safe operation (Figure 2-1;
Figure 2-2).
1. Be sure that the installation area is clean and dry.
Use hot soapy water and dry the area thoroughly
before installing decals.
2. Determine the exact position by taking
measurements and test tting before you remove
the backing paper.
3. For safety labels with no top protection paper,
determine the label location and remove the
smallest portion of the split backing paper.
4. Align the label over the specied area and carefully
press the small portion with the exposed adhesive
backing into place.
5. Peel back the remaining paper and carefully smooth
the remaining portion of the label in place.
6. Small air pockets can be pierced with a pin and
smoothed out using the piece of label backing
paper.
7. If the label has a protective top paper, use hot soapy
water on the surface to which the label is being
applied. Leave wet. After determining the location,
remove the backing paper and soak the label in
clean soapy water before application. This will help
prevent air bubbles in the nished label.
8. Smooth the label into place with a sponge and
check for air bubbles. Small air pockets may be
pierced with a pin and smoothed out. When the label
is completely smoothed out, carefully remove the
top paper.
Return to
Last Viewed
Return to
Thumb Index