LEGRAND 3440 - Page 172

163
HD4657M3
HD4657M4
HC4657M3
HC4657M4
HS4657M3
HS4657M4
573912
573913
After installing the device wait two minutes for auto-calibration to end.
During this time, commands may be automatically sent to the system.
!
Congurator in SET position Behaviour
0 • LED ON even if button not congured
• No status return
• Fade eect on
1 • LED ON even if button not congured
• No status return
• Fade eect o
2 • LED ON only if congured (not congured -> LED OFF)
• No status return
• Fade eect on
3 • LED ON only if congured (not congured -> LED OFF)
• No status return
• Fade eect o
4 • LED ON even if button not congured
• Status return on
• Fade eect on
5 • LED ON even if button not congured
• Status return on
• Fade eect o
6 • LED ON only if congured (not congured -> LED OFF)
• Status return on
• Fade eect on
7 • LED ON only if congured (not congured -> LED OFF)
• Status return on
• Fade eect o
Selecting the LED display mode
You can choose:
- whether at rest to keep the LEDs that are not used/congured o or on;
- whether to illuminate the LEDs or not when you press the corresponding button
(status return); to obtain an optimal status return eect it is recommended to set a
low LED brightness level.
- whether or not to give the illuminating buttons a "fade" eect.
Touch control
MQ00110-f-EN 07/06/2014
Virtual configuration (MYHOME_Suite) Physical configuration
Function Parameter / setting
Feedback update YES, NO SET=0-7
1)
NOTE 1: To choose the configurator, see the following table: