29
N+ – L
5
4
8
3
2
7 6
1
H4594
LN4594573548
Actuator for the control of Ballasts for 0-10 V type Fluorescent tube lamps with power
up to 1000 W max , with ON/OFF LED.
Description
Legend
1. NETWORK key
2. + key: press and release immediately to activate the load at 66% of its power; press
and hold down to increase the power to the maximum value.
3. NETWORK LED
4. LEARNING LED
5. - key: press and release immediately to activate the load at 33% of its power; press
and hold down to decrease the power to the minimum value.
6. Load ON/OFF LED
7. ON/OFF key
8. LEARNING key
Wiring diagram
Size: 2 flush mounted modules
Dimensional data
“Push and Learn” self-learning type.
Configuration
Front view
Important:
– Connect a load before performing any “scenario” learning
procedure.
– For conventional type transformers, a load with power 60%
higher than their rated power must be connected.
– For the calculation of the controllable power take into account
the efficiency of standard transformers (e.g.: transformer for a 50
W lamp with an efficiency of 0.78 => power actually absorbed
by the transformer = 64 VA)
Power supply: 100 – 240 Vac 50/60 Hz
Operating temperature: 5 – 45 °C
Technology: Radio 2.4 GHz standard ZigBee®
Capacity: 150 m free field, 15 m in rooms with
concrete walls
Power/absorption of the loads driven: see following table
Technical data
Voltage
Ballast 0 – 10 V
230 Vac 1000 VA
110 Vac 500 VA
Dimmer RF for ballasts 0-10V 1000W
MQ00404-b-EN 22/04/2014
To Next Page
Loading...
