LEGRAND 3440 - Page 287

278
N°
Z
AUX
MOD
1 4
O N
5
PL
A
G1
G2
M
14
L L1
HD4611
HS4611
N4611
L4611
NT4611
AM5791
573938 (White)
573939 (Magnesium)
067502
HC4611
AUX 1 2 3 4 5 6 7 8 9
Time 1 min. 2 min. 3 min. 4 min. 5 min. 15 min. 30 sec. 0.5 sec 2 sec.
AUTOMATION mode – GENERIC CONTROL USING AUXILIARY CHANNELS:
In this case, the actuator is managed by a control device, item H/L4651M2, 067553 or
AM5831M2, which, based on its own operating mode, set in its own M position, activates
the actuator with address set in A and PL.
The communication between the detector and the associated control device is
established by dening an auxiliary channel that has been congured in the IR detector
by connecting the AUX congurator to the MOD position, and specifying, with numeric
congurators 1-9 in the AUX position, the number of the auxiliary channel. Obviously, in
order to univocally establish the auxiliary channel, also the AUX position of the control
must have the same congurator as the IR detector.
ActuatorIR detector
Example of conguration
Conguration
AUTOMATION mode – TIMED CONTROL:
Passive IR detectors can generate and send an ON timed control directly to one or more
actuators.
For this mode, congure in the Z and N positions of the detector the addresses A and PL
of the actuator to control respectively.
To the MOD position connect the ON congurator to enable the time delay function.
The switching ON period is set by connecting numerical congurators 1 to 9 to the AUX
position as shown in the following table:
Passive IR detector
MQ00036-c-EN 29/04/2014