Use
39
7 USE
7.1 General Instructions
Before the first use it is recommendable - with fully lowered implement - to carry
out the following adjustments at the farm and to make familiar with the machine
and its functions. Afterwards only few adjustment corrections have to be carried
out in the field.
7.2 Upper control link length
Lower the plough.
Turn the upper control link until the plough standing on even ground is 1 to 3 cm
higher at the front than at the rear.
If the upper control link is in the slot, it must be turned until the top link pin is at the
front of the slot when the plough is lowered and the plough is also 1 to 3 cm high-
er at the front than at the rear.
7.3 Support wheel or depth and transport wheel
Adjust the support wheel or depth and transport wheel as required for the in-
tended working depth.
Swivel the support wheel to the stop.
Measure the vertical distance between the lower edge of the wheel and the
share level.
Correct the vertical distance between the lower edge of the wheel and the share
level if required.
7.4 Skimmer
See "Skimmer" section in the "Settings" chapter.
To Next Page
Loading...
