Adjustments
48
10.1.3 Front furrow width, mechanical, in conjunction with hydraulic frame
swivel
DANGER
In conjunction with the hydraulic frame swivel, the base frame
first swivels in and then out again before the turn.
A pinch point is located between hydraulic cylinder and the ad-
juster sleeve.
Ensure that sufficient safety clearance is maintained.
In place of the outer spindle, a hydraulic
cylinder with adjuster sleeve (1) is used
and is hydraulically connected to the rotary
cylinder.
Lower the implement.
Release the clamping screw (2).
To prevent contaminants from damaging the seal (3), ensure that
the setting of the adjuster sleeve (1) matches the one shown in
the figure when performing the adjustment.
Move the hydraulic cylinder out slightly to relieve the adjuster sleeve (1).
Briefly operate the control unit for the rotary cylinder = connection P1 is pressur-
ised.
Front furrow too narrow
Rotate the adjuster sleeve (1) longer = dimension A larger.
Front furrow too wide
Rotate the adjuster sleeve (1) shorter = dimension A smaller.
A
1
2
3
To Next Page
Loading...
