Adjustments
56
10.8 Landside
Standard assembly
Assembly for work on a slope
To achieve better control on a slope, the
landside (1) can be set to a lower position.
Undo the screw (3).
Remove the screw (2).
Set the landside (1) to its lowest posi-
tion.
Replace the screw (2).
Tighten all screws again. Tighten all
screws again. See «Tightening torques,
page 86».
10.9 Skimmer
10.9.1 General information
The skimmers should work at a depth of
around 5 - 10 cm. If you want to plough at
a depth of 25 cm, for example, the skim-
mers should be adjusted so that the rele-
vant share tip on the skimmer is at a dis-
tance A of around 15-20 cm from the share
tip on the plough base.
1
2
3
1
2
3
To Next Page
Loading...
