LEMKEN Juwel 7 - Clearance to the Side

Adjustments
62
10.12.3 Clearance to the side
The clearance between the side of the
coulter (6) and the edge of the slat is set
by:
 pivoting the stalk (7) or
 moving the pin in the oblong hole (11).
 Loosen the corresponding screws /
nuts(1 or 8).
 Set the clearance by:
 pivoting the stalk (7)
or
 moving the pin in the oblong hole (11)
until the required position is reached.
 Re-tighten the screws / nuts (1 or 8), see
«Tightening torques, page 86».
1
6
7
11
6
1
8
8
6
7