Attaching and Detaching the Plough
25
5.2 Detaching
− Park the plough on a firm and level
ground!
− Turn plough to working position!
− Set tractor hydraulics to ‘Position Con-
trol’!
− Lower plough completely!
− Make hydraulic hoses pressureless! See operating manual of the tractors
manufacturer!
− Remove top link from headstock!
− Remove hydraulic hoses and fit protective caps.
− Put hydraulic hoses with their couplings between headstock (7) and adjuster nut
(8)!
− Remove securing pin (3) up to the stop!
− Release stand (2), remove as required
and swing-down!
− Lock securing pin (3) and check,
whether it is locked correctly!
− Remove lower links from the drawbar!
Attention! When the plough is parked the headstock (7) is in oblique position,
which can make a later re-attachment difficult. So before parking the
plough the headstock (7) should be “set straight” by means of corre-
sponding adjustment of the adjuster nut (8). This eases the later at-
tachment. Before the next use, set the headstock to original position
again by means of turning back the adjuster nut by the same amount!
2
3
7
2
To Next Page
Loading...
