Adjustments
38
• Risk of crushing and shearing in the area between the stopper
arm and the end stop! Keep to a sufficient safety distance!
8.4 Working Depth
The working depth adjustment occurs via the tractor hydraulics and the depth
wheel of the plough. The instructions for the adjustment of the tractor hydraulics
can be learned from the operating manual of the tractor manufacturer. In each ca-
se the tractor hydraulics must be set to ‘Draft’ or ‘Mixed’ control.
The depth wheel of the plough is used as control wheel and prevents that the
plough works too deep. That is why the plough weight should be transferred to the
tractor as far as possible to prevent too much slippage. Too much slippage leads
to premature wear of the wheel and increased fuel consumption.
To Next Page
Loading...
