DVD drive
connector
Cable connector latch
DVD drive cable
Figure84.DVDdrivecableroutingfor3.5-inchharddiskdriveservermodels
Step6.Replacetheairbaffle(see“Replacingtheairbaffle”onpage122).
Step7.Reinstallthecover(see“Replacingthecover”onpage120).
Step8.Slidetheserverintotherack.
Step9.Reconnectthepowercordsandanycablesthatyouremoved.
Step10.Turnontheperipheraldevicesandtheserver.
Removingamemorymodule
Usethisinformationtoremoveamemorymodule.
Toremoveadualinlinememorymodule(DIMM),completethefollowingsteps:
Step1.Readthesafetyinformationthatbeginson“Safety”onpagevand“Installationguidelines”on
page116
.
Step2.Turnofftheserverandperipheraldevicesanddisconnectallpowercords.
Step3.Removethecover(see“Removingthecover”onpage119).
Chapter5.Removingandreplacingcomponents159