Lenovo System x3550 M5 - Removing the Serveraid Adapter Memory Module

SAS/SATA signal
cables
SAS/SATA power cable
SAS/SATA power
connector
SAS/SATA
configuration
connector
SAS/SATA power cable
Figure115.ServeRAIDadaptercableroutingfortwelve2.5-inchhot-swapharddiskdriveconfiguration
Step8.ConnectthesignalcablestotheSAS/SATAadapter.
Step9.Reconnectanycablesthatyouremoved.
Step10.ReplacePCIriser-cardassembly1ifyouhaveremoveditearlier(see“ReplacingaPCIriser-card
assembly”onpage172).
Step11.Reinstallthecover(see“Replacingthecover”onpage120).
Step12.Turnontheperipheraldevicesandtheserver.
Step13.ImportyourRAIDconfigurationtothereplacementServeRAIDadapteras
aforeignconfiguration.SeetheServeRAID-MSoftwareUserGuideat
https://www-947.ibm.com/support/entry/portal/docdisplay?lndocid=migr-5086126for
instructions.
Note:Whenyourestarttheserver,youarepromptedtoimporttheexistingRAIDconfigurationtothe
newServeRAIDadapter.
RemovingtheServeRAIDadaptermemorymodule
UsethisinformationtoremovetheServeRAIDadaptermemorymodule.
ToremovetheServeRAIDadaptermemorymodule,completethefollowingsteps:
Chapter5.Removingandreplacingcomponents191