Stepsforinstallingaten2.5-inchhot-swapharddiskdrivebackplanewithtwoNVMedrive
connectors
a.Alignthebackplanewiththeslotsonthechassis.
b.Carefullylowertheharddiskdrivebackplaneuntilitisfullyseatedinthechassis.
Ten 2.5-inch hard disk drive backplane
(with two NVMe connectors)
Figure134.Installationofa10x2.5-inchhot-swapharddiskdrivebackplanewithtwoNVMeconnectors
c.InstalltheNVMeadaptertothePCIExpressslot2(low-profile).See“Replacinganadapter”
onpage178.
Note:YoucanviewtheNVMeadapterinformationintheSetupUtilityprogramonlywhenyour
serverhasthefollowinghardwareinstalled:
•PCIeriser2assembly(FRUnumber:00KF627)
•Twomicroprocessors
Chapter5.Removingandreplacingcomponents215