Figure 25. Removing the bay 1 drive cage
Step 3. Remove the front bezel.
a.
Release the three plastic tabs on the front bezel.
b.
Rotate the front bezel to remove it from the chassis.
Figure 26. Removing the front bezel
Step 4. Remove the bay 0 drive cage.
a.
From the outside of the chassis, remove the screw that secures the bay 0 drive cage to the
chassis.
b.
From the inside of the chassis, remove the screw that secures the bay 0 drive cage to the
chassis.
c.
Pull the bay 0 drive cage out from the chassis.
48
ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
