Make sure the screw holes that are nearest to the drive connector are outside of the drive
retainer.
Figure 46. Drive screw hole placement on retainer
1 Screw holes nearest to the drive connector
Step 2. Install the bay 2+bay 3 drive cage assembly into the chassis.
a. Align the four pins on the sides of the bay 3 drive cage with the four slots on the chassis and
cage bar; then, lower the drive cage assembly into the chassis.
b.
Ensure that the drive cage assembly is seated correctly; then, rotate the handle on the bay 3
drive cage toward the front of the chassis to secure the drive cage assembly into place.
66
ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
