Figure 64. Installing the optical drive cage to the bay 2 drive cage
Step 4. If applicable, install the 3.5-inch drive to the bay 2 drive cage. See
“Install a simple-swap drive (bay
2)” on page 54
.
Step 5. Install the ODD+bay 2 drive cage assembly.
a.
Align the four pins on the sides of the optical drive cage with the four slots on the chassis
and cage bar; then, lower the drive cage assembly into the chassis.
b.
Ensure that the drive cage assembly is seated correctly; then, rotate the handle on the
optical drive cage toward the front of the chassis to secure the drive cage assembly into place.
82
ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
