Lenze i700

5 Motor control & motor settings
5.3 Wiring check by means of manual test modes
65
Lenze · i700 servo inverter · reference manual · DMS 3.0 EN · 06/2016 · TD06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Subindex 3: Manual test mode: Starting angle
Selection of the starting angle for test mode
Note!
In the case of the synchronous motor, a jerky compensating movement occurs after controller enable if the pole
position of this movement does not correspond to the starting angle.
Setting range (min. value | unit | max. value) Lenze setting
-1000.0 ° 1000.0 0.0 °
 Write access  CINH  OSC  P  RX  TX Scaling: 1/10 INTEGER_16