2-34 Service Manual
5056-XXX
Menus are Disabled The printer menus are disabled.
You cannot change the printer
settings from the operator panel.
Note: You can still cancel a job, print
a confidential job, or print a held job.
Network See action column. A network interface is the active
communication link.
Network <x>
Network <x>, <y> See action column. A network interface is the active
communication link, where <x>
represents the active communication
link, and <y> represents the channel.
No DRAM installed The DRAM is missing or not
properly installed.
Turn the printer off, and install
DRAM.
No held jobs Wait for the message to clear.
No jobs found The four-digit personal
identification number (PIN) you
entered is not associated with any
confidential print job.
Select Try again to enter another
PIN.
Select Cancel to exit the Enter
PIN screen.
No jobs to cancel Wait for the message to clear.
No recognized file types Wait for the message to clear.
Note: The only supported file type is
PDF.
Parallel See action column. A parallel interface is the active
communication link.
Parallel <x>
Port disabled Remove USB drive Wait for the message to clear.
Power Saver The printer is in Power Saver
Mode. It is ready to receive a print
job.
Send a job to print.
Press Select to warm the printer to
normal operating temperature and
display the Ready message.
Printer locked, enter PIN to unlock The operator panel has been
locked.
Enter the correct PIN number to
unlock the printer.
Printing Wait for the message to clear.
Printing from USB drive
DO NOT REMOVE
A job on the USB drive is being
processed.
Warning: Do not turn the printer off
or remove the USB drive while this
message is displayed.
Wait for the message to clear.
Printer busy
Continue
Quit
Select Continue to read the
information from the USB drive.
Select Quit to cancel the
information retrieval process.
Programming System Code New system code is being
programmed into the printer.
Warning: Do not turn the printer off
while this message is displayed.
Wait for the message to clear and
the printer to reset.
Programming Flash Printer resources are being stored
to the flash memory.
Warning: Do not turn the printer off
while this message is displayed.
Wait for the message to clear.
Programming Disk Printer resources are being stored
to the hard disk drive.
Warning: Do not turn the printer off
while this message is displayed.
Wait for the message to clear.
Reading USB drive DO NOT
REMOVE
Wait for the message to clear.
Message Meaning Action
To Next Page
Loading...
