Diagnostic information 2-39
5056-XXX
40 Tray <x> size sense error The hi-cap feeder detects an error
in the size sensing mechanism.
-Select Continue to clear the
message and continue printing.
The job may not print correctly.
-Cancel the current job.
-Turn the printer off, check high
capacity feeder connectors, then turn
the printer on.
41 Open bin 1 exit tray The printer wants to send a job to
the bin 1 output tray, but the tray is
closed.
-Open the bin 1 exit tray located on
the left side of the printer.
-Cancel the current job.
-Select Continue to clear the
message and print to another output
bin.
51 Defective flash detected Self explanatory. Select Continue to clear the
message and continue printing.
You must install different flash
memory before you can download
any resources to flash.
52 Not enough free space in flash
memory for resources
Self explanatory. -Select Continue to clear the
message and continue printing.
Downloaded fonts and macros not
previously stored in flash memory
are deleted.
-Delete fonts, macros, and other data
stored on the flash memory.
-Install a larger capacity flash
memory card.
53 Unformatted flash detected Self explanatory. Select Continue to clear the
message and continue printing.
You must format the flash memory
before you can store any resources
on it. If the error message remains,
the flash memory may be defective
and require replacing.
54 Serial option <x> error The printer has detected a serial
interface error on a serial port.
-Make sure the serial link is set up
correctly, and you are using the
appropriate cable.
-Make sure the serial interface
parameters (protocol, baud, parity,
and data bits) are set correctly on the
printer and host computer.
-Select Continue to clear the
message and continue printing.
The job may not print correctly.
-Turn the printer off and then on to
reset the printer.
54 Network <x> software error The printer cannot establish
communications with the specified
network port.
-Select Continue to clear the
message and continue printing.
The job may not print correctly.
-Program new firmware for the
network interface.
-Reset the printer.
54 Standard network software
error
55 Unsupported flash option in
slot <x>
1. Turn the printer off.
2. Remove the unsupported option.
3. Turn the printer on.
55 Unsupported option in slot <x>
Message Meaning Action
To Next Page
Loading...
