USING THE PROGRAM
Exp.I/O
Item Description
Device Type
Select a device type.
y ACS I/O, AO I/O, UI I/O, DO I/O, DI I/O
Unit Name
(20
Characters)
Enter the device name.
y Up to 20 characters.
Address
(00-FF)
Type the central control address of the device.
y A central control address value is a number between 00 and FF. You cannot
type the same value for similar devices.
Add at once
y It is used when you need to add several devices of the same type.
y Select check box, input the desired number of devices, and the devices are
added at once, and the device name and address are automatically increased.
(During the Add all, if duplicate address value occurs, the information notice
message for the duplicate address is displayed.)
NOTES
y
The detail ports of Exp.I/O can be modified during device edit. For detail setting of Exp.I/O,
refer to Exp.I/O Detail Setting.
y
After registering or changing Exp.I/O device, the AC S IV Controller must be rebooted.
y
Be sure to perform a database backup prior to Auto addressing. Auto addressing does not find
any I/O Modules or points created from previous installation.
NOTES
Address of the products linked to the MODBUS communication system recommend a number
between 01~F7.
To Next Page
Loading...
Need help?
General
