USING THE PROGRAM
Auto Logic
Auto Logic allows the system to automatically control the power consumption of external devices.
You can also set the indoor temperature to automatically adjust to selected variables or activate
devices for certain periods of time.
NOTES
If you set a device control value in the auto logic status view, the device can operate based on
that value.
Peak Control
Peak control limits peak power consumption. You can set the target operating rate so that total
power consumption does not exceed the set limit. To prevent power consumption from exceeding the
limit, the system will switch automatically between cooling and fan modes. Also it will limit heating
operation by switching automatically between Heat and OFF modes.
NOTES
Depending on the installation site specifications, either the peak control or demand control
functions can be selected. Go to Environment > Advance Setting > Peak/Demand Set and
select a desired control type.
To Next Page
Loading...
Need help?
General
