USING THE PROGRAM
Demand Control
After observing changes in power consumption, this feature can prevent power consumption from
exceeding a set limit. If you set the demand control and the program predicts that power consumption
will exceed that limit, it will begin deactivating less important devices to save energy.
NOTES
y
For demand, depending on the installation site specifications, either the peak control or
demand control functions can be selected. Go To Environment > Advance Setting > Peak/
Demand Settings and select a desired control type.
y
For outdoor capacity control, depending on the installation site specifications, either the peak
control or demand control functions can be selected.
y
In the Demand Control menu, you can only check the Demand Control status. You cannot
configure the operation, operation switchover cycle, desired rate, current rate, etc.
NOTES
y
ACS IV Controller can be used with the LG demand controllers (PCP-D11A2J), but not with the
demand controllers from other manufacturers.
y
LG demand controller is not available in the US Market at this time.
To Next Page
Loading...
Need help?
General
