Page 175 of 295
Recommendations
• LINAK recommends safe cabling to avoid cable damage caused by pulling.
• A product review as to current cut-off limits must be requested by the sales department.
• Always use matching cable plug for the respective product.
• Push plugs fully into correct sockets and make sure they are firmly inserted.
• Mount the OPS box lid and close lid until locked in place.
Heat pad cable
Always use 6-wire cables.
Please note that angled heat pad cable plugs are required for connection to the control box.
Order no. 0965361-A (1100 mm straight cable).
Warnings
• Use EPR or ensure that the user takes care not to squeeze the mains cable.
• Always check correct assembly after mounting and service to ensure that the cable lock is mounted. (Connectors are usually removed during cleaning)
• Take special precautions concerning 3
rd
party interfacing. Please contact LINAK for further information.
• Make a review of all product specifications before system set-up if the OPS box current cut-off limit is higher than the maximum allowed current
heat pad cut-off.
• Make a proper cable installation to avoid cable interruption and inspect regularly for wear and damage. Replace defective parts.
• Make regular inspections for wear and damage to avoid electrical failure or system disturbance and replace defective parts.
• Make a proper cable installation to avoid short-circuit of hand control cables. Make regular inspection for wear and damage and replace defective parts.
To Next Page
Loading...
Need help?
General
