Page 265 of 295
9. Information on specific LIFT products
1. CAL40 (MEDLINE
®
CARELINE
®
)
The control box CAL40 is part of the LIFT40 product series specially
developed for patient lifts.
LIFT40 is a complete system consisting of the control box CAL40 or
CAL40+, a battery BAL40 and an external charger CHL40 in a flexible
solution. Combined with one or more actuators and a hand control you
have a complete system for modern patient lifts.
Usage
• With internal charger: Nominal current draw max. 350 mA (depending on input voltage)
Standby power of 230 VAC = 0.7 W (depending on input voltage)
Improved BLE might give lower power consumption
Input voltage range: 120-240 VAC (50/60 Hz)
Power consumption (charging): max. 30 W (depending on input voltage)
• Duty cycle: Max. 10%, 2 minutes continuous use followed by 18 minutes without use
• Operating temperature: +5 °C to +40 °C
• Storage temperature: -10 °C to +50 °C
• Relative humidity: 20% to 80% - non-condensing
• Atmospheric pressure: 700 to 1060 hPa
• Meters above sea level: Max. 3000 meters
• Approvals: CAL40
EN IEC 60601-1
ANSI/AAMI ES60601-1
CAN/CSA-C22.2 NO. 60601-1
EN IEC 60601-1-2
CAL40+
EN IEC 60601-1
ANSI/AAMI ES60601-1
CAN/CSA-C22.2 NO. 60601-1
EN IEC 60601-1-2
RED (EU) (pending)
FCC ID (US) (pending)
IC ID (Canada) (pending)
Telec (Japan) (pending)
Instructions for use
• Default functionality – when charging, the LIFT40 will not be able to operate any actuators
• It is only possible to use the battery BAL40 with either of the CAL40 control boxes
• Use only original LINAK mains cables to ensure proper connection to internal charger
To Next Page
Loading...
Need help?
General
