To Next Page

To Previous Page

Gocator Line Profile Sensors: User Manual

Protocols • 504

Indicator ID Instance Value

-Value exceeds bit representation available for

given protocol

-Analog output (mA) falls outside of acceptable

range (0-20 mA)

When a measurement value overflow occurs, the

value is set to the null value appropriate for the

given protocol's measurement value output type.

The Overflow health indicator increments.

Tool Run Time 22004 Tool Index The most recent time taken to execute the tool.

Part Total Emitted 22006 - Total number of parts emitted by profile part

detection.

Part Length Limit 22007 - Number of parts emitted due to reaching the

length limit.

Part Min Area Drops 22008 - Number of parts dropped due to being smaller

than the minimum area.

Part Backtrack Drops 22009 - Number of parts dropped due to backtracking.

Parts Currently Active 22010 - Number of parts currently being tracked.

Part Length 22011 - Length of largest active part.

Part Start Y 22012 - Start Y position of the largest active part.

Part Tracking State 22013 - Tracking state of the largest active part.

Part Capacity Exceeded 22014 - Part detection part or run capacity has been

exceeded.

Part X Position 22015 - Center X position of the largest active part.

*When the sensor is accelerated, the indicator's value is reported from the accelerating PC.

** When the sensor is accelerated, the indicator's value is the sum of the values reported from the

sensor and the accelerating PC.

LMI Technologies Gocator 2380 User Manual

Questions and Answers: