Logicube Forensic Falcon - Page 104

TYPES OF OPERATIONS
Logicube Forensic Falcon™ User’s Manual 95
a password. By default, this is set to 1 minute.
A shortcut (and indicator) to the config lock can
always be seen on the Falcon’s screen. It is
located on the top-right of the screen, next to
the Falcon logo.
While in a locked state, the following operations
will be affected as follows:
 Imaging – An imaging task can be
started, but no settings can be changed.
Additionally, no new task can be added,
and no task can be deleted without the
unlock key.
 Hash – A hash task can be started, but
no settings can be changed.
Additionally, no new task can be added,
and no task can be deleted without the
unlock key.
 Wipe – A wipe task can be started, but
no settings can be changed.
Additionally, no new task can be added,
and no task can be deleted without the
unlock key.
 Task Macro – A task macro can be
started, but no settings can be changed.
Additionally, no new macro can be set
or edited without the unlock key.
 USB Device – Since there are no
settings or configurations for this
operation, it is not affected by Config
Lock.
 File Browser – The file browser cannot
be accessed without the unlock key.
 Logs – Since there are no settings or
configurations for this operation, it is
not affected by Config Lock.