Logicube Forensic Falcon

CHANGING DEFAULT PASSWORDS
Logicube Forensic Falcon™ User’s Manual 154
passwd: password updated successfully
7. Type the following command then press the Enter key:
sudo mount -o remount,ro /
8. Press the following key combinations to go back to the Graphical User
Interface: Alt+1
16.0.3 Changing only the it password
For the username: it
13. Connect a USB keyboard one of the two USB ports in front of the Falcon
then use the following key combinations: Alt+2 then Alt+Shift+Enter.
14. Once logicube prompt appears, type the following commands, one line
at a time (Press the Enter key after each command/line):
sudo mount -o remount,rw /
sudo passwd it
15. The following prompt will appear:
Enter new UNIX password:
16. Type a new password then press the Enter key. The following prompt
will appear:
Enter new UNIX password:
17. Type the new password again then press the Enter key. The following
response should appear:
passwd: password updated successfully
18. Type the following command then press the Enter key:
sudo mount -o remount,ro /
19. Press the following key combinations to go back to the Graphical User
Interface: Alt+1