PREVIEWING DRIVES
Logicube Forensic Falcon™ User’s Manual 38
4.5 iSCSI
Another way to access Source drives from a computer (through a direct network cable
connection or through a network) is through the iSCSI protocol. This method allows both
physical and logical access to the drives, but may require additional software installed and
configured on the computer. To use the iSCSI protocol, an iSCSI initiator must be installed and
configured to view the contents of drives connected to the Falcon over a network.
Like using SMB, some advantages of using this method are:
The contents of the drive are searchable using the Operating System’s search functions.
Third party analysis tools and software can be used with the logical partition.
See Section 11.2 for details on how to view Source drives over the network using iSCSI.
To Next Page
Loading...