VIEWING DRIVES OVER NETWORK
Logicube Forensic Falcon™ User’s Manual 133
11.2 Viewing Source drives over the network using iSCSI
An iSCSI initiator must be configured to view the contents of Source drives over a network.
Although there are many iSCSI initiators available, these next sections will discuss configuring
Microsoft’s iSCSI initiator in Windows.
11.2.1 Configuring the iSCSI initiator – Windows 7, 8, and 8.1
1. Open the iSCSI initiator. In the Target tab, enter the Falcon’s host name
or IP address in the Target field. Click the Quick Connect button to
continue.
2. The Quick Connect window will appear and any drives connected to the
Source ports of the Falcon will appear on the list of discovered targets.
Highlight the drive to view, then click Connect.
To Next Page
Loading...