Logicube Forensic Falcon User Manual

DRIVE ENCRYPTION & DECRYPTION
Logicube Forensic Falcon™ User’s Manual 118
2. Select the encrypted disk to mount (in this example, it is Disk #5). Place
a check mark on the Entire disk option. FreeOTFE cannot read the
partition table on the drive since it is encrypted at this time.
3. In the Key tab, enter the Key (password) and make sure the Hash is set
to RIPEMD-160.
4. In the Encryption tab, set the Cipher to AES (256 bit CBC). Set the
Initialization Vector (IV) generation method to match what was used in
the IV Generation on the Falcon. In this example, “plain64’ was used. In
the ‘Sector zero location’, choose Start of encrypted data.

Logicube Forensic Falcon Specifications

General

Brand	Logicube
Model	Forensic Falcon
Category	Storage
Language	English