Logicube Forensic Falcon User Manual

IMAGING
Logicube Forensic Falcon™ User’s Manual 58
When finished, the status will change to COMPLETED. At this point, it is recommended to tap
Reset Task to reset the task, and also to delete the task in order for the drive bays to be properly
reset and not show as being used or assigned for other tasks to be configured.
The number of bytes shown on the progress bar is not the actual size of the drive.
This is the actual data being processed. When ‘Verify’ is set to “Yes”, the reported
number will double in size.
For parallel imaging, prior to starting the first task, users must set all other tasks
that need to be run in parallel. When all other tasks to be run in parallel are set, a
confirmation screen will appear stating there are multiple tasks setup with the
same Source drive.
Falcon can automatically span to two (or more) Destination drives when using
Drive to File mode (DD, E01, EX01). When the Destination drive is full and the
remaining data to be imaged will not fit, Falcon will prompt for another drive.
Information on Drive Spanning can be found in Section 3.1.1.2.

Logicube Forensic Falcon Specifications

General

Brand	Logicube
Model	Forensic Falcon
Category	Storage
Language	English