EasyManuals Logo

Lorex NR800 Series User Manual

Lorex NR800 Series
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #172 background imageLoading...
Page #172 background image
Troubleshooting
24
When a malfunction occurs, it may not be serious and can be corrected easily. The fol-
lowing describes the most common problems and solutions. Please refer to the following
before calling Lorex Technical Support:
Error
Possible Causes Solutions
System is not receiving
power, or is not powering up.
Cable from power adapter is
loose or is unplugged.
Confirm that all cables are
connected correctly.
Confirm that the power
adapter is securely con-
nected to the back of the unit.
Power switch is set to OFF (
) position.
Confirm that the power
switch is in the ON (I)
position.
Cables are connected, but
system is not receiving suffi-
cient power.
Confirm that the system is
powered on (LED indicators
on the front should be ON).
If the unit is connected
through a power bar or surge
protector, try bypassing the
bar and connecting the
power directly to the wall
outlet.
Confirm that there is power
at the outlet:
Connect the power cable
to another outlet.
Test the outlet with anoth-
er device (such as a lamp
or phone charger).
Hard drive is not detected
by the system.
Hard drive cables are loose
or not properly connected.
Remove the housing and
check that hard drive cables
are firmly connected.
There is no hard drive in the
system.
Open the housing and install
compatible hard drive. Make
sure to format the drive after
installing. For details, see .
Hard drive is full (0%) and
the unit is no longer
recording.
Overwrite is not enabled.
From the Main Menu, select
>Setting>Gener-
al>General. Select Overwrite
under HDD Full and click OK.
There is no picture on moni-
tor/TV after connecting it to
the system.
Monitor/TV not detected by
system.
Power off the monitor/TV
and system. Power on the
monitor/TV, and then power
on the system.
Input channel for system not
selected on monitor/TV.
On the monitor/TV, select
the input channel the system
is connected to.
Video cable is loose or has
become disconnected.
Check the video cable con-
nection to the system and
monitor/TV.
#LX400021; r. 4.0/30344/30494; en-US
162

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lorex NR800 Series and is the answer not in the manual?

Lorex NR800 Series Specifications

General IconGeneral
BrandLorex
ModelNR800 Series
CategoryNetwork Hardware
LanguageEnglish

Related product manuals