Sent XXXX bytes in XXX seconds
tftp>
X varies according to the configuration of the router.
30. Type and enter quit
Response:
asm0#
31. On the Supervisor Console, display the Main Menu page if it is not already
displayed:
• If the * prompt is displayed, type and enter 9999 at the * prompt to display
the DynaStar Supervisor page. Continue with the steps below indicating what
to do if the DynaStar Supervisor page is displayed.
• If the DynaStar Supervisor page is displayed:
a. Type and enter secret (or the password set for your office) at the Enter
Password: prompt.
Response:
The Supervisor Console Types information appears.
b. Type and enter 2 (for VT100 or ANSI compatible) at the Enter Console
Type: prompt.
Response:
The Main Menu page is displayed.
• If one of the other menu pages is displayed, press the [Esc] key repeatedly
until the Main Menu page is displayed.
32. On the Main Menu page, type and enter 4 for System functions.
Response: The System Commands menu is displayed.
33. Type and enter 6 to Reinitialize.
Response: The Reinitialize page is displayed.
34. Type and enter secret (or the password set for your office) at the Enter Current
Password: prompt.
Response: While the Router is reinitializing, the Router executes power-on self
tests which output status messages onto the Supervisor Console,
and cause the LEDs on the front of the Router to go through a series
of changes. The initial color of the LEDs are yellow/orange, which
turn to red, briefly flash to green, and then completely turn off.
At the conclusion of the power-on self testing, the top row of LEDs
light up on the Router, and the DynaStar Supervisor page is
displayed on the Supervisor Console.
35. After the DynaStar
4
initializes, the unit should be active. If there is no other
problem the link from the ASM to the DRM should restore. If not, seek technical
support .
4. Trademark of DynaStar, Inc.
235-200-150
October 2004
NETWORK PROCEDURES
Procedure 3.6
Issue 3.00L Page 3.6-5
To Next Page
Loading...
Need help?
General