EasyManuals Logo

Lucent 5ESS DRM User Manual

Default Icon
642 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #267 background imageLoading...
Page #267 background image
4.17 Replace a DVD Drive (
Netra
1
240)
OVERVIEW
This procedure is used to replace the DVD drive on a Netra 240 Administrative
Workstation. The DVD drive in the Netra 240 is not hot-swappable. The AW must be
powered down and the power input cables disconnected before replacing the DVD
drive.
Caution: The DVD drive contains a laser device. If the replacement
procedures are not followed, the user risks being exposed to radiation.
PROCEDURE
1. Halt the AW (see "Halt the Administrative Workstation," Procedure 4.2).
2. Remove power to the AW (see “Remove Power to Administrative Workstation
Units (Netra 240)”, Procedure 4.9).
3. Grip the bezel at the two finger holds and rotate it down to open (see Figure
4.17-1).
4. Unclip the catches that fasten the DVD drive to the chassis (see Figure 4.17-2).
1. Registered trademark of Sun Microsystems, Inc.
Figure 4.17-1 NETRA 240 Front Fingerholds
235-200-150
October 2005
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.17
Issue 8.00O Page 4.17-1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent 5ESS DRM and is the answer not in the manual?

Lucent 5ESS DRM Specifications

General IconGeneral
BrandLucent
Model5ESS DRM
CategoryControl Unit
LanguageEnglish