4.5.8 Format the Primary or Secondary Disk from a Boot CD-ROM (
Netra
1
20 or
Netra
240)
PROCEDURE
1. Stop the AW. See “Halt the Administrative Workstation,” Procedure 4.2.
2. Load the 3B21 Emulator and Operating System CD-ROM into the CD-ROM/DVD
drive.
3. Enter the following command at the ok prompt to boot the AW from the
CD-ROM/DVD:
boot cdrom
If “cdrom” is not defined correctly, use the following commands to verify the
CD-ROM/DVD drive device ID and set the CD-ROM device alias:
For a Netra 20:
devalias
nvalias cdrom /pci@8,700000/scsi@6/disk@6,0:f
For a Netra 240:
devalias
nvalias cdrom /pci@1e,600000/ide@d/cdrom@0,0:f
The AW starts to boot from the CD-ROM, messages similar to those shown in the
following example are output on the system console:
For a Netra 20:
Resetting ...
Sun Netra T4 (UltraSPARC-III+), No keyboard
Copyright 1998-2002 Sun Microsystems, Inc. All rights reserved.
OpenBoot 4.5, 512 MB memory installed, Serial #51344136.
Ethernet address 0:3:ba:f:73:8, Host ID: 830f7308.
Initializing Memory
Rebooting with command: boot cdrom
Boot device: /pci@8,700000/scsi@6/disk@6,0:f File and args:
SunOS Release 5.8 Version Generic-108528-13 64-bit
Copyright 1983-2001 Sun Microsystems, Inc. All rights reserved.
.
.
.
For a Netra 240:
Resetting ...
Netra 240, No keyboard
Copyright 1998-2003 Sun Microsystems, Inc. All rights reserved.
OpenBoot 4.11.4, 1024 MB memory installed, Serial #59810525.
Ethernet address 0:3:ba:90:a2:dd, Host ID: 8390a2dd.
Initializing Memory
Rebooting with command: boot cdrom
Boot device: /pci@1e,600000/ide@d/cdrom@0,0:f File and args:
1. Trademark of Sun Microsystems, Inc.
235-200-150
October 2005
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.5.8
Issue 3.00B Page 4.5.8-1