Distinctive Remote Module (DRM)
CONTENTS PAGE
3. NETWORK PROCEDURES................... 3-1
3.1 Local Log on to the Networking Router ........... 3.1-1
3.2 Remote Log on to The Networking Router .......... 3.2-1
3.3 Back Up the
DynaStar 500
(Base/Growth) Router
Configuration File at the DRM Site ............. 3.3-1
3.4 Back Up The
DynaStar 500
(Base/Growth) Router
Configuration File at the Host Site ............. 3.4-1
3.5 Restore the Configuration Settings for the
DynaStar 500
(Base/Growth) Router at the DRM Site ........... 3.5-1
3.6 Restore the Configuration Settings for the
DynaStar 500
(Base/Growth) Router at the
5ESS
®
Switch Host Site...... 3.6-1
3.7 Configure the Router to Support Serial Asynchronous
Interface (SAI) at the DRM Site .............. 3.7-1
3.8 Set up the High Speed Interface to send NFM/SCC data to
the
5ESS
®
Switch Host Site ............... 3.8-1
3.9 Set up the High Speed Interface to Send EADAS Data to the
Host Site ....................... 3.9-1
3.10 Install the BRI to PRI to Back up the T1 ........... 3.10-1
3.11 DRM Network Element Software Download Procedure ..... 3.11-1
3.12 Cajun Switch Software Version Procedure .......... 3.12-1
3.13 DynaStar Router Software Version Procedure ........ 3.13-1
3.14 Replace the Cajun P333T Ethernet Switch .......... 3.14-1
3.15 Replace A
DynaStar 500
Host Router or Remote Router .... 3.15-1
LIST OF FIGURES
Figure 3.5-1 — Example of
Ethernet
Interface Parameters Screen With
Field Values .................... 3.5-2
Figure 3.7-1 — PAD Port Configuration Menu with Sample Field Input . . . 3.7-2
Figure 3.7-2 — The Async Services Menu with Sample Field Values .... 3.7-3
235-200-150
October 2005
NETWORK PROCEDURES
Issue 3.00M Page 3-i
3.7-3
3.7-2
3.5-2
3.15-1
3.14-1
3.13-1
3.12-1
3.11-1
3.10-1
3.9-1
3.8-1
3.7-1
3.6-1
3.5-1
3.4-1
3.3-1
3.2-1
3.1-1
3-1