3.2 Remote Log on to The Networking Router
Purpose
Use this procedure to access the networking router from a remote location on the
network.
When to Use
This procedure is performed prior to:
• configuring the router from the host site
• backing up the router configuration files from the host site
• restoring the DRM networking router from the host site.
Before You Begin
A supervisor console (VT100 terminal or laptop) must be connected to the network.
Required Tools
The following equipment is required to perform the procedure:
• PC with VT100 emulator software or a VT100 terminal is connected to the
network.
Required Information
Before beginning this procedure, you must have the telnet address of the DynaStar
500
1
router to be accessed. (This information should be stored in the office records.)
PROCEDURE
1. Enter telnet X
X = ip_address of the DynaStar 500 to be accessed.
(For example, telnet 10.10.9.254)
Response: The services page appears:
1 CONSOLE 61b6
2 x25PDN DynaStar 633
3 x25PDN DynaStar 634
2. Enter 2 for the X25PDN choice.
Response: *
3. Enter 9999.
Response: Enter password:
4. Enter secret or the password set for your office.
Response: The Supervisory Console page is displayed:
Enter Console Type:
Supervisor Console Types
1–Myse 50 or TVI-910/920
2–VT100 or ANSI compatible
1. Trademark of DYMEC, Inc.
235-200-150
January 2003
NETWORK PROCEDURES
Procedure 3.2
Issue 3.00 Page 3.2-1
To Next Page
Loading...
Need help?
General