3.4 Back Up The
DynaStar 500
1
(Base/Growth) Router Configuration File at the
Host Site
Purpose
Use this procedure to backup the configuration settings for the router at the 5ESS
®
switch host site.
When To Use
This procedure is performed whenever a new router has been installed and configured,
or any new information is added to the configuration file.
Before You Begin
Required Tools
The following equipment is required to perform the procedure:
• The ASM at the host site
• Supervisor console permissions
Required Conditions
Prior to performing this procedure, perform the following:
• Log onto the ASM and access the ASM GUI Switch Complex page. For more
information on ASM procedures, see document 235–200–145, OneLink Manager
™
Administrative Services Module User’s Guide.
• From the ASM GUI Switch Complex page, login to the ASM shell.
Required Information
Before beginning this procedure, you must have the IP address of the DynaStar 500
router whose configuration files are to be backed up. This should be stored in the
office records.
PROCEDURE
1. At the ASM prompt (asm0#), cd to the directory that contains the backup file of
the host router to be updated:
Enter cd /varapp/dynastar/host_X
Where: X = ‘a’ if Host DynaStar Router 00 is being backed up
‘b’ if Host DynaStar Router 01 is being backed up
‘c’ if Host DynaStar Router 02 is being backed up
Response: asm0#
Note: : If the directory does not exist, execute the following commands and
repeat step 1:
mkdir /varapp/dynastar
mkdir /varapp/dynastar/host_X
1. Trademark of DYMEC, Inc.
235-200-150
April 2004
NETWORK PROCEDURES
Procedure 3.4
Issue 3.00G Page 3.4-1
To Next Page
Loading...
Need help?
General