2. Enter pwd
Response: asm0# /varapp/dynastar/host_X
asm0#
Where: X = ‘a’ if Host DynaStar Router 00 is being backed up
‘b’ if Host DynaStar Router 01 is being backed up
‘c’ if Host DynaStar Router 02 is being backed up
3. Enter tftp X
where X is the IP address of Ethernet
2
port at the router
(For example, tftp 10.10.1.254.)
Response: tftp>
4. Enter ascii
Response: tftp>
5. Enter get config
Response: Received XXXXX bytes in X seconds
tftp>
X = variables indicating number of bytes per seconds.
6. Enter binary
Response: tftp>
7. Enter get cnfgload.cmp
Response: Received XXXX bytes in XXX seconds
tftp>
8. Enter quit
Response: asm0#
9. Enter ls -l
Response: total XXX
-rw-r--r-- 1 root other XXXX Jul 26 10:23 cnfgload.cmp
-rw-r--r-- 1 root other XXXXX Jul 26 10:23 config
Back up ASM to Tape. See document 235-200–145, OneLink Manager
Administrative Services Module User’s Guide
2. Registered trademark of Xerox Corporation.
NETWORK PROCEDURES
Procedure 3.4
235-200-150
April 2004
Page 3.4-2 Issue 3.00G
To Next Page
Loading...