3.5 Restore the Configuration Settings for the
DynaStar 500
1
(Base/Growth) Router
at the DRM Site
Purpose
The following procedure restores the configuration settings for the router at the DRM
site.
When to Use
The following procedure is used when restoring the original setting:
• after the router has been replaced, or
• due to a router that is malfunctioning.
Before You Begin
Required Conditions
This procedure requires:
• The faulty unit be replaced and all ports reconnected
• Use Procedure 3.1 Local Log on to the Networking Router, to display the Main
Menu page of the unit.
Required Information
The following host router designations are used for this procedure:
• Base = host_a
• Growth = host_b
• Growth = host_c
To identify the IP address values, browse /dynastar/config from the DRM UNIX
2
console. The values are listed after the following variables:
• routerAdminIPAddress
• routerAdminIPMask
• Protocol is RIP II
• Encaps is Enet II
PROCEDURE
1. On the Main Menu page, type and enter 3 for Configuration.
Response: The Configuration Commands menu is displayed.
2. Type and enter 2 for Port.
Response: The Configure Port menu is displayed.
3. Type and enter 0 for Ethernet
3
.
Response: The Ethernet Interface Parameters page is displayed. See Figure
3.5-1.
1. Trademark of DYMEC, Inc.
2. Registered trademark in the United States and other countries licensed exclusively through X/Open
Company Limited
3. Registered trademark of Xerox Corporation.
235-200-150
October 2004
NETWORK PROCEDURES
Procedure 3.5
Issue 3.00L Page 3.5-1
To Next Page
Loading...