EasyManuals Logo

Lucent 5ESS DRM User Manual

Default Icon
642 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #505 background imageLoading...
Page #505 background image
8.12 Perform RMAS Data Link Growth
OVERVIEW
This procedure is used to grow the Remote Memory Administration System (RMAS)
X.25 data link using ECD low-level forms. This OS uses bx.25 session layer over x.25.
This procedure assumes the most common connection, which is using x.25 PVCs over
a direct connection between the OS and the datalink (through a Modem, Router,
IPDSU, etc).
This procedure assumes the link is to be grown on port 3 of the DRM’s high speed
interface (HSI).
Note: RMAS requires 5e15 and later to work in the DRM.
The following hardware must be on site:
RS422 to RS232 converter (Black Box part # IC456A)
RS422 cable (Black Box part # EDN37J-00XX-MM; where XX is the cable length
in feet)
RS232 cable (Black Box part # ECM25C-0010-MM)
This procedure takes approximately 2 hours to complete.
PROCEDURE
1. This process is a combination of procedures. Perform these procedures in the
order in which they are presented.
1. “Grow in RMAS Data Link in ECD,” Procedure 8.12.1.
2. “Connect Hardware for RMAS Data Link,” Procedure 8.12.2.
3. “Configure RMAS RC Access,” Procedure 8.12.3.
4. “Verify Operation of RMAS Data Link,” Procedure 8.12.4.
235-200-150
January 2006
GROWTH AND DEGROWTH
Procedure 8.12
Issue 3.01 Page 8.12-1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent 5ESS DRM and is the answer not in the manual?

Lucent 5ESS DRM Specifications

General IconGeneral
BrandLucent
Model5ESS DRM
CategoryControl Unit
LanguageEnglish