8.6 Grow Remote
Sun
1
Console Dial-Up Modem Access
OVERVIEW
Through the use of commercially/Lucent available hardware, another option for
accessing the DRM’s Sun console is over a dial-up modem connection.
Note: Transmitted and received data will be echoed on both the local (if equipped)
and dial-up Sun console (this configuration does not provide two separate independent
Sun console interfaces to the DRM). As a result, care must be taken to ensure that
two operators do not try accessing the Sun console at the same time.
Table 8.6-1 lists the required hardware for the dial-up Sun console.
Table 8.6-1 — Dial-Up
Sun
Console Hardware Requirements
Item Lucent Comcode 3rd Party Source
Serial Splitter 407947290 Black Box Corp
TL073A-R2
Modem A
a
(local
modem)
106597768 Paradyne Corp
Model 3810
Modem B (remote
modem)
106597768 Paradyne Corp
Model 3810
or
Any 9600 baud compatible modem
Cable 1 407645092 (10ft)
or
407645118 (50ft)
Black Box Corp EYN251-0010-MM
(10ft)
or
EYN251-0050-MM (50ft)
Cable 2 407645092 (10ft)
or
407645118 (50ft)
Black Box Corp EYN251-0010-MM
(10ft)
or
EYN251-0050-MM (50ft)
Cable 3
b
407667351 (25ft)
or
407667369 (50ft)
or
407667377 (100ft)
Black Box Corp EDN16C-0025-MM
(25ft)
or
EDN16C-0050-MM (50ft)
or
EDN16C-0100-MM (100ft)
Cable 4 407947340 (50ft) Black Box Corp EVNLS03–0050
(50ft)
or
Standard CAT5 RJ45 cable
Cable Adapter (RJ45
female to DB25 male
straight-through
connector)
403602717 Northern Technologies FM-010
1. Registered trademark of Sun Microsystems, Inc.
235-200-150
October 2005
GROWTH AND DEGROWTH
Procedure 8.6
See note(s) at end of table.
Issue 3.00B Page 8.6-1
To Next Page
Loading...