Table 8.6-1 — Dial-Up
Sun
Console Hardware Requirements (Contd)
Item Lucent Comcode 3rd Party Source
Dial-Up Sun Console
Terminal
407552488 (KS23996
MCC), 408800027
(KS24697L1 MCC)
or
PC running Lucent’s
AIMS terminal
emulator software
Any vt100 compatible terminal
c
or
PC running a vt100 terminal
emulator
Note(s):
a. A generic 9600 baud modem is not recommended for the local modem.
b. If a PC running the Lucent AIMS terminal emulator software is being used as the
local Sun console terminal, a DB25 to DB9 connector adapter may also be
required depending on the type of serial port equipped on the PC running the
AIMS software. Cable 4 and the cable adapter are not needed when connecting to
a local PC running AIMS. Refer to Figure 8.6-1 for more information.
c. Not supported by Lucent Technologies
PROCEDURE
Warning: This growth procedure requires the workstation to be halted and
powered down. This procedure should be scheduled to ensure that it does not
interfere with any other planned maintenance activity.
1. Ensure that there is no Recent Change/Verify (RC/V) activity in progress.
2. Ensure that there is no SCANS session in progress.
3. Ensure that there is no AMA teleprocessing or tape writing sessions in progress.
4. Verify that all database updates have been written to disk.
(a) Enter the following input command on the MCC or a STLWS: BKUP:ODD;
Response: BKUP ODD COMPLETED
5. Write all AMA billing records from memory to disk.
(a) Type and enter command: WRT:AMADATA
Response: AMA DATA HAS BEEN WRITTEN TO DISK
READY TO TRANSFER DATA FROM DISK TO
OUTPUT MEDIUM
6. Isolate the switching module from the AW.
(a) Go to the Switching Module Inhibit and Recovery Control Page. Type and
enter command: 1800
(b) Manually isolate the switching module. Type and enter: 403
Response: ISOLATE (Y/N)
(c) Type and enter: Y
Response: SET ISOL SM=1 COMPLETED
GROWTH AND DEGROWTH
Procedure 8.6
235-200-150
October 2005
Page 8.6-2 Issue 3.00B
To Next Page
Loading...
Need help?
General