7. Enter poke 59 on the MCC EAI page to halt the AM emulator.
Response: Terminate Emulator (Y/N)?
8. Type and enter: y
9. Switch to the Sun UNIX
2
Console of the AW by holding down the Ctrl key and
pressing the Enter key on the MCC’s numeric keypad.
10. If a login prompt does not appear, press Return repeatedly until one appears.
11. At the login prompt, type and enter: awadmin
12. From the Administrative Workstation Main Menu, select the "Halt the
Workstation" option. Answer yes to the confirmation. If you select a task by
mistake, answer no to the confirmation and the main menu will appear.
Response:
You have chosen to halt the workstation. If the emulator is running,
it must be halted before continuing. Refer to the main menu item of
Halt the Emulator.
Do you want to continue (yes/no): yes
13. Wait for the ok prompt to appear.
14. Power down the AW units and Sun console terminal in the following order:
For a Netra
3
t 1120 or Netra 20 workstation:
1. Netra t 1120 and Netra 20 workstation. See "Remove Power to
Administrative Workstation (Netra t 1120 and Netra 20)", Procedure 4.7.
2. Sun console terminal
For a Netra 240 workstation:
1. Netra 240 workstation and external tape device. See "Remove Power to
Administrative Workstation Units (Netra 240)", Procedure 4.9.
2. Sun console terminal
15. Connect the dial-up Sun console hardware as shown in Figure 8.6-1. Refer to
Table 8.6-1 for cable designations.
2. Registered trademark in the United States and other countries, licensed exclusively through X/Open
Company, Limited.
3. Trademark of Sun Microsystems, Inc.
235-200-150
October 2005
GROWTH AND DEGROWTH
Procedure 8.6
Issue 3.00B Page 8.6-3
To Next Page
Loading...
Need help?
General