4.5.7 Format the Secondary Disk from a Boot CD-ROM (
Netra
1
t 1120)
PROCEDURE
1. Stop the AW. See “Halt the Administrative Workstation,” Procedure 4.2.
2. Load the 3B21 Emulator and Operating System CD-ROM into the CD-ROM
drive.
3. Enter the following command at the ok prompt to boot the AW from the
CD-ROM/DVD-ROM:
boot cdrom
If “cdrom” is not defined correctly, use the following commands to verify the
CD-ROM drive SCSI ID and set the CD-ROM device alias:
devalias
nvalias cdrom /pci@1f,4000/scsi@3/disk@5,0:f
The AW starts to boot from the CD-ROM, messages similar to those shown in the
following example are output on the system console:
Resetting ...
screen not found.
Can’t open input device.
Keyboard not present. Using ttya for input and output.
Sun Ultra 60 UPA/PCI (UltraSPARC-II 440 MHz), No keyboard
OpenBoot 3.29, 512 MB memory installed, Serial #13079967
Ethernet address 8:0:20:c7:95:9f, Host ID: 80c7959f.
Initializing Memory
Rebooting with command: boot cdrom
Boot device: /pci@1f,4000/scsi@3/disk@5,0:f File and args:
SunOS Release 5.8 Version Generic-108528-13 64-bit
Copyright 1983-2001 Sun Microsystems, Inc. All rights reserved
.
.
.
After the system boots on the CD-ROM, the 3B21 Emulator and Operating
System CD-ROM Installation main menu is displayed.
4. From the main menu, select "Format and Load the Secondary Disk from
CD-ROM" Answer yes to the confirmation. If you select a task by mistake,
answer no to the confirmation.
Response:
You have chosen to format and load the secondary disk from CD-ROM.
WARNING:
If you continue, the secondary disk operating system partitions will
be overwritten with data from the CD-ROM and its MHD partitions are
preserved.
Do you want to continue? (yes/no) yes
This task will take approximately 30 minutes. Answer no if the following
question is asked:
1. Trademark of Sun Microsystems, Inc.
235-200-150
January 2003
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.5.7
Issue 3.00 Page 4.5.7-1
To Next Page
Loading...
Need help?
General