3.9 Set up the High Speed Interface to Send EADAS Data to the Host Site
Purpose
The following procedure is used to set up the High Speed Interface to send EADAS
data to the Host Site.
Reason to Perform
The following procedure should be used to provide access to DRM High Speed
Interface ports by connecting the High Speed Interface ports to the customer
operational support services (OSS).
Before You Begin
The following factors must be considered before you begin the procedure:
Required Conditions
The following conditions should exist before the procedure is performed:
• Verify that the router is connected to the network.
• Verify that a terminal (laptop computer or VT100 terminal) is connected to the
network.
PROCEDURE
3.9.1 Access the High Speed Interface
1. Access the High Speed Interface from:
• a control display cut-through window, or
• an MCC.
3.9.2 Install the EADAS Router at the DRM Site
1. Perform Procedure 8.11 to grow TDMS/EADAS Data Links and connect the High
Speed Interface port to the router port cable.
3.9.3 Configure the Router at the DRM Site
3.9.3.1 Assign the High Speed Interface Port on the Router at the DRM site
1. Perform Procedure 3.2 to remotely log on to the networking router.
2. Enter 3 for configuration.
Response: The Configuration Commands menu is displayed.
3. Enter 2 for port.
Response: The Configure Port menu is displayed.
4. Enter 2 for Quad-Card.
Response: The Configure Port menu is displayed.
5. Enter 204
Response: The PPP Synchronous Port Configuration menu is displayed.
235-200-150
January 2003
NETWORK PROCEDURES
Procedure 3.9
Issue 3.00 Page 3.9-1
To Next Page
Loading...
Need help?
General