8.11.5 Initialize TDMS/EADAS Processes
PROCEDURE
1. At the MCC, type and enter: INIT:ULARP
Response: INIT ULARP COMPLETED
2. At the MCC, type and enter the following commands:
INIT:AM,OKP,SPP,PID=27
INIT:AM,OKP,SPP,PID=19
INIT:AM,OKP,SPP,PID=80
Note: The following steps are optional but can be used to verify that the correct
processes are running on the DRM to support the EADAS/TDMS data link. These
steps can be used at anytime to verify the processes are active.
3. At the MCC, type and enter poke 194 to go to the SCREEN view. If a STLWS
terminal is being used, enter the 120 poke to clear the screen, enter the
rcv:menu:sh input command, and then skip to step 5.
4. Type and enter: u to request access to the UNIX
1
Shell.
5. At the UNIX prompt, type and enter the following command:
ps -axkp | grep "as"
Response: The expected response should be (not necessarily in this order):
10 ? 78 /no5text/as/ECap
1 ? 98 /no5text/rcv/RCasrsys
10 ? 4784235 /no5text/as/ECr3
10 ? 1638508 /no5text/as/ECr4
10 ? 110 /no5text/as/AScotsys
10 ? 262258 /no5text/as/ECr6
10 ? 65651 /no5text/as/ECw6
10 ? 65652 /no5text/as/ECw3
10 ? 65653 /no5text/as/ECw4
10 ? 120 grep as
6. In order for the EADAS/TDMS data link to function properly, the ECap, ECr3,
ECr4, ECr6, ECw3, ECw4, and ECw6 processes must be listed in the report
indicating that those processes are running.
7. Type and enter: exit at the UNIX prompt.
8. If you are using the MCC, type and enter: q to exit out of the 194 SCREEN view.
9. THIS IS A SAFE STOPPING POINT.
1. Registered trademark in the United States and other countries, licensed exclusively through X/Open
Company, Limited.
235-200-150
January 2003
GROWTH AND DEGROWTH
Procedure 8.11.5
Issue 3.00 Page 8.11.5-1
To Next Page
Loading...
Need help?
General