3.15 Replace A
DynaStar 500
1
Host Router or Remote Router
Purpose
This procedure replaces a defective DynaStar 500 Host Router or Remote Router in
the Lucent Network Component Solution (LNCS) configuration with a replacement
DynaStar 500 Host Router or Remote Router.
When to Use
This procedure is used to replace a defective DynaStar 500 Router with a replacement
DynaStar 500 Router. The use of any other DynaStar Router model, a Router of
another manufacturer, or a DynaStar 500 Router configured outside the scope of the
LNCS configuration is not supported by this procedure.
Before You Begin
Before replacing the defective Router, preliminary checks should be performed to
ensure that the failure of the Router was not caused by loss of power to the unit,
power switch(s) inadvertently placed to the off position, or the failure of an Ethernet
interface cable.
Required Tools
The following equipment is required to perform the procedure:
• A replacement Router.
If a Host Router is being replaced, the replacement Router must be a
replacement Host Router of the same equipage as the defective Host Router.
If a Remote Router is being replaced, the replacement Router must be a
replacement Remote Router of the same equipage as the defective Remote
Router.
• Supervisor Console (PC with VT100 emulator software or a VT100 terminal)
configured as follows (see table 3.15-1):
1. Trademark of DYMEC, Inc.
235-200-150
October 2004
NETWORK PROCEDURES
Procedure 3.15
Issue 3.00L Page 3.15-1
To Next Page
Loading...
Need help?
General