3.3 Back Up the
DynaStar 500
1
(Base/Growth) Router Configuration File at the
DRM Site
Purpose
Use this procedure to backup the configuration settings for the router at the DRM
site.
When To Use
This procedure is performed whenever a new router has been installed and configured,
or any new information is added to the configuration file.
Before You Begin
Required Tools
The following equipment is required to perform the procedure:
• PC with VT100 emulator software or a VT100 terminal connected to the network.
• Supervisor console permissions.
Required Conditions
The following conditions should exist before the procedure is performed:
• Log onto the Administrative Workstation (AW) console.
• Perform Procedure 3.1 Local Log on to the Networking Router, or Procedure 3.2
Remote Log on to the Networking Router, depending on location.
Required Information
Before beginning this procedure, you must have the IP address of the DynaStar 500
router whose configuration files are to be backed up. This should be stored in the
office records.
PROCEDURE
1. At the prompt (#), enter cd /dynastar
Response: #
Note: If the directory does not exist, execute the following command and repeat
this step :mkdir /dynastar
2. Enter pwd
Response: /dynastar
#
3. Enter tftp X
X = IP address of router’s Ethernet
2
port.
(For example, tftp 10.10.9.254)
Response: tftp
4. Enter ascii
Response: tftp>
1. Trademark of DYMEC, Inc.
2. Registered trademark of Xerox Corporation.
235-200-150
April 2004
NETWORK PROCEDURES
Procedure 3.3
Issue 3.00G Page 3.3-1
To Next Page
Loading...
Need help?
General