SunOS Release 5.8 Version Generic-108528-29 64-bit
Copyright 1983-2003 Sun Microsystems, Inc. All rights reserved.
.
.
.
After the system boots on the CD-ROM, the 3B21 Emulator and Operating
System CD-ROM Installation main menu is displayed.
4. Is this procedure being used to format the primary disk?
If YES, proceed with Step 5.
If NO, proceed with Step 6.
5. From the main menu, select "Format and Load the Primary Disk from CD-ROM"
.Answer yes to the confirmation. If you select a task by mistake, answer no to
the confirmation.
Response:
You have chosen to format and load the primary disk from CD-ROM.
WARNING:
If you continue, the primary disk operating system partitions will
be overwritten with data from the CD-ROM and its MHD partitions are
preserved.
Do you want to continue? (yes/no) yes
This task will take approximately 30 minutes.
When it is completed, you will be prompted to press Return. When the prompt
appears, press Return and continue with step 7.
6. From the main menu, select "Format and Load the Secondary Disk from
CD-ROM". Answer yes to the confirmation. If you select a task by mistake,
answer no to the confirmation.
Response:
You have chosen to format and load the secondary disk from CD-ROM.
WARNING:
If you continue, the secondary disk operating system partitions will
be overwritten with data from the CD-ROM and its MHD partitions are
preserved.
Do you want to continue? (yes/no) yes
This task will take approximately 30 minutes. Answer yes if the following
question is asked:
Do you want to change /etc/vfstab to make the secondary disk bootable? yes
When it is completed, you will be prompted to press Return. When the prompt
appears, press Return.
7. From the main menu, select “Display the Workstation Default Boot Disk”.
Is the default boot device set to the desired disk?
If YES, enter return and proceed with Step 9
If NO, enter return and proceed with Step 8.
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.5.8
235-200-150
October 2005
Page 4.5.8-2 Issue 3.00B